Publicidad
Idiomas disponibles
Idiomas disponibles
FILL-UP AND START-UP INSTRUCTIONS
The following procedures should be followed
on initial startup and whenever the spa is
drained for routine maintenance.
FILLING THE SPA WITH
WATER
1. Clear all the debris from your spa.
2. Be sure to open all jets to allow as much
air as possible to escape from the plumb-
ing during the filling process.
3. Insert a garden hose into filter
compartment to fill your spa.
NOTE: Do not use hot or softened water.
4. As the water level rises, check inside
the equipment compartment for water
leaks. It may be necessary to tighten
unions and/or fittings that may have
loosened during delivery. There is no
need to call for service; this can easily be
done. If assistance is required, contact a
Customer Service representative at (888)
961-7727 Ext. 8440.
UNIONS
5. Under normal circumstances keep the
water level half way between the top of
the spa and the top of the gray filter ring
or just above the highest jets (whichever
is higher).
Failure to keep enough water in your spa
may result in damage to your system
and invalidate your warranty. If your spa
filter is sucking in air causing the pump to
cavitate, you need to add water!
6. Check the filter installation and make sure
the filter is not loose.
APPLYING POWER
1. Turn power to spa "ON" (after filling spa)
from the main panel at the house and the
subpanel.
2. Press the Jets button on the topside
control panel to activate the spa. Rotate
all the air control valves counterclockwise
and observe the increased jet action (air
mixed with water).
3. While the pump is running check again
for water leaks at the drain spigot, unions,
or fittings in the equipment compartment
(leaks may have occurred during transit).
If water is leaking from one of these
areas, there is no need to call for service.
Simply tighten the fitting. If assistance
is required, call a Customer Service
representative at (888) 961-7727 Ext.
8440.
4. After checking your spa for leaks it is now
time to adjust your spa settings. Press
the Plus or Minus button on your topside
control panel until the display indicates
your desired temperature is set.
15
Publicidad
