Publicidad
Idiomas disponibles
Idiomas disponibles
HVF046A
manual
10/22/01
ii:05
AM
Pag_
Unpackin
9 Your
Wine
¢oo er
1, Remove all packaging
material.
This includes the foam base and all
adhesive
tape holding
the wine cooler
accessories
inside and outside,
Slide out and remove
plastic or foam
guard used to secure the
compressor
from shipping
damage
due to vibration
and shock,
2. Inspect and remove any remains
of packing,
tape or printed
materials
before powering
on the wine cooler,
[eye,in
9 Your
Wine
Coo ÷r
• Your wine cooler has four leveling legs which are located
in the
front and rear corners
of your wine cooler.
After properly
placing
your
wine cooler
in its final position,
you can level your wine cooler.
• Levelin 9 legs can be adjusted
by turning
them clockwise
to raise your
wine cooler or by turning
them counterclockwise
to lower
your wine cooler, The wine cooler door will close easier when the
leveling legs are extended.
Proper Air Circulation
• To assure your wine cooler works at the maximum
efficiency
it
was designed
for, you should install it in a location
where there
is proper
air circulation,
plumbing
and electrical
connections.
• The following
are recommended
clearances
around
the wine cooler:
Sides ...............
2 "(50ram)
Top ....................
2" (50ram)
Back ..................
2" (50ram)
• Do not over fill your wine cooler for proper
internal
air circulation.
Publicidad
