Publicidad
Idiomas disponibles
Idiomas disponibles
Thank you for purchasing this Price Pfi ster bathroom faucet. All Price Pfi ster products are carefully engineered and factory tested to provide
long trouble-free use under normal conditions. This bathroom faucet is easy to install using basic tools and our easy to follow illustrated in-
structions. If you have any questions regarding your bathroom faucet installation, call 1-800-Pfaucet (1-800-732-8238)
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfi ster
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE plumber's tap
• Plumber's putty
• Philips head screwdriver
• Pliers
• Flashlight
• Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
FAUCET INSTALLATION
Your faucet can be installed with or without the deck plate:
For installation using the deck plate:
For installation without using the deck plate:
• Slotted screwdriver
• Adjustable wrench
Go To Step 4
Go To Step 4
Go To Step 9
Go To Step 9
ENGLISH
INSTALLATION USING DECK PLATE
4
BOTTOM GROOVE
4 PUTTY PLATE ATTACHMENT
(For installation without the deck plate, go to step 9.)
Place a bead of plumber's putty in the groove along the outer edge of the Putty Plate
(4A). Install the Putty Plate (4A) over the three holes in your sink.
5
5 DECK PLATE INSTALLATION
Press Deck Plate (5A) onto Putty Plate (5B).
6
6D
6B
6C
6 SPOUT INSTALLATION
Insert Spout Shank (6A) through the center hole. From underneath sink, place Mounting
Washer (6B) onto Spout Shank (6A) and tighten with Mounting Nut (6C). Before fi nal
tightening, be sure Spout (6D) is centered and facing forward.
2
.
4A
5A
5B
6A
Publicidad
