Publicidad
Idiomas disponibles
Idiomas disponibles
11
11B
11A
11C
11E
11 UNDERBODY INSTALLATION
From underneath, insert Underbody (11A) through Mounting Holes (11B) with Shank
labeled "HOT" on left side (11C), and Shank labeled "COLD" on right side (11D). Align
Socket (11E) onto Spout Shank (11F), push Underbody (11A) up until the top of Socket
(11E) reaches the Spout Shank Stop (11F). Be careful not to damage the O-Ring Seals
(11G). Attach Locknut (11H) and forcefuly tig hten the until the Underbody (11A) is
fi rmly assembled to the Spout Shank (11F).
12
RANURA
INFERIOR
12C
12 HANDLE ADAPTER ATTACHMENT
Place a bead of plumber's putty in the bottom groove along the outer edge of Putty Rings
(12A). Press Putty Rings (12A) onto the bottom edge of Handle Adapters (12B). Thread
the Handle Adapters (12B) over the Valve Stems (12C) and tighten so that the Handle
Adapters (12B) sit on top of Putty Rings (12A).
13
13A
13 POP-UP ROD CONNECTIONS
Insert Lift Rod (13A) into hole at top of Spout Head (13B). Gently, slide Lift Rod (12A)
down the Spout Head hole (13B).
11B
11G
11F
11D
11H
12B
12A
12B
12A
12C
13B
ENGLISH
14
14B
14 HANDLE INSTALLATION
Connect Handles (14A) onto Valve Stems (14B).
15
15 SECURING HANDLES
Be sure Valves and Levers are in the "OFF" position. Secure handles by holding the Le-
ver (15B) in place and tighten the Hubs (15A) by rotating them in a clockwise direction.
To remove handles, rotate Hubs (15A) in a counterclockwise direction.
16
16B
HOT
16A
16 WATER SUPPLY CONNECTIONS
Connect water Supply Lines (16A) to Faucet Inlets (16B). Hot water supply lines go into
left inlet. Cold water supply lines go into right inlet. (Supply lines not included). Please
follow manufacturer's instructions when installing supply lines.
4
14A
14B
15B
15A
16B
COLD
16A
14A
Publicidad
