Sears Kenmore Elite 790.4715 Manual Del Usuario página 8

Setting Surface Controls
Sizes of the Surface Gas Burners
Your appliance is supplied with
the following 4 different surface
gas burners:
o Simmer Burner (5,000 BTU)
o Standard Burner (9,500 BTU)
o Power Burner (12,000 BTU)
Power Burner (17,000 BTU)
When setting up the range for the
first time, make sure that the
correct Burner Heads, Burner
Caps and Burner Grates are
bcated as shown in Figure 1,
Burner CaD
(Standard)...
Standard
Burner
(9.500 BTU
"D
Left Front
Orifice Holder
sLarge Burner Cae
"POWER
f m
- Burner Head
_ S(12,000
BTU_
Left Rear
/ ,,
Onflce Holder
Extra Large
Burner CaD "_,_.j21::i
"POWER" _ _/_
Burner Head £
(17,000 BTU)
Right Front
Figure 1
Orifice Holder
Sma
_Burner Cap
_"BIMMER"
Burner Head
(5,000 BTU)
Right Rear
Orifice Holder
Grate
Pin
Burner
Grate
Electrode must be
located properly in slot
of each Burner Head
Figure 2
Assembly of the Surface Burner Heads, Burner Caps and
Burner Grates
it is very important to make sure that aHof the Surface Burner Heads,
Surface Burner Caps and Surface Burner Grates are installed correctUy
and at the correct bcations,
1, PUaceaH 4 Burner Heads in the correct bcations (See Figure 1),
Make sure that the correct Burner Head is placed with the
corresponding Orifice Holder and that the Electrode is located
properly in the slot of each Burner Head (See Figure 2), Proper Burner
Head placement insures that each Burner will have the correct spark
required for surface gas ignition,
2, Place the correct Burner Caps at each of the burner locations (Burner
Cap Pilot Hob must face up), Each of the 4 (four) Burner Heads
MUST have a Burner Cap installed to insure proper ignition and gas
flame size and must be in place with the Pilot Hob facing up
BEFORE placing the Burner Grates (See Figure 2),
3, Place the 2 (two) cast iron Burner Grates supplied with the range,
Carefully line-up the 2 Grate Pins on each Grate with the Cap Pilot
Hobs in the 2 Burner Caps on each side of the range, DO NOT force
the Burner Grates onto the Burner Caps, Forcing the grates down
onto improperly installed Burner Heads and Burner Caps may damage
the gas burners, Each Burner Cap is designed with a Cap Pilot Hob
in the top center of the Cap, Visually check that ALL the Grate Pins
line up into the Burner Cap Pilot Hobs (See Figure 2), Properly
installed Burner Grates will rest with all four Grate legs on the glass
cooktop,
REMEMBER -- DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS
OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER
OPENING. Always keep the Burner Caps and Burner Heads in place
whenever the surface burners are in use,