Descargar Imprimir esta página

Shark RS-JET CARBON Manual página 21

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

PRECAUTIONS AND
RECOMMENDATIONS
1. Even though our helmet meets global
approval standards for helmet production,
always ride carefully. A helmet cannot
fully protect the user from all possible
collisions at high or low speed. All safety
equipment has its limits, and a head injury
is possible in an accident despite wea-
ring a helmet. However, to protect against
fatal accident or permanent impairment
due to head injury, the size of the helmet
must match the size of your head and the
chin strap must be properly tightened and
locked as indicated in this manual.
2. This helmet is designed to cushion
impact by the partial destruction of the
shell and/or the internal shock absor-
ber. This damage may not be apparent.
Therefore, if the helmet suffers an impact,
even simply being dropped to the ground,
it must be returned to be checked,
replaced or destroyed, even if it does not
appear damaged. If there is any doubt, and
if you are not sure that this rule applies
for the impact in question, contact your
supplier before using the helmet again.
3. Like any product, a helmet can deterio-
rate over time depending on the condi-
tions of use. Please check the helmet for
signs of deterioration or damage before
each use. The size of the helmet should
always match the size of your head. If not,
then the helmet has expanded, and you
need to replace it. Never wear a damaged
helmet. Even if the helmet is not damaged
or deteriorated, it is recommended to
change it five years after purchase.
4. Do not make any changes to the helmet.
Never pierce or cut any part of the helmet.
Any change may damage the helmet, and
therefore reduce its effectiveness in pro-
tecting you from an impact.
5. Handle the helmet with care. Never
sit on it or throw it on the ground. Never
ride with the helmet hanging on any part
of the bike.
6. Never use petroleum or petroleum
products, chemicals or any other solvent
to clean the helmet, shell or visor.
Additionally, never expose your helmet
to the vapours of these solvents (for
example, by leaving it on the fuel cap of
your motorcycle). The helmet could be
seriously damaged by these chemical
agents, without it being apparent, the-
refore reducing the effectiveness of the
2
helmet in protecting you. Use only mild
soap, warm water and a soft cloth to clean
and wipe the helmet and visor.
7. Never apply paint, stickers or tape to
your shell or visor. These could damage
your helmet, without it being apparent,
and therefore reduce the effectiveness of
the helmet in protecting you.
8. No customization or modification
should alter the quality of the original
design or manufacturing. The addition of
accessories not approved by the helmet
manufacturer (action camera; communi-
cation kit, decorative accessories, etc.)
may alter the protective performance
guaranteed by the helmet manufactu-
rer. Only accessories recommended and
evaluated by the manufacturer during
the helmet approval procedure can gua-
rantee that the protective performance
of the helmet remains compliant with the
approval standards. Approved accessories
must be installed in accordance with the
helmet manufacturer's instructions in this
manual.
9. A reduction in hearing, field of vision
and head movements will be noted when
wearing the helmet. Please adapt your
riding accordingly.
10. Dry your helmet at room temperature.
Never expose it to a temperature above
approximately 160°F/70°C, which could,
for example, happen if your helmet was
left on the passenger seat or in the trunk
of a car. Always keep the helmet away
from heat sources, such as the exhaust
pipe or the bike casing.
11. For any comments or questions regar-
ding the helmet, please contact SHARK or
your nearest supplier.
WARNING! We do not guarantee
the ability of this product to fully
protect the user from all possible colli-
sions at high or low speed, or from inju-
ries that could be fatal. The helmet user
recognizes and acknowledges that there
are risks inherent to riding a motorbike,
which are not limited to collisions of any
kind, at high or low speed. By purchasing
and using this product, the user expressly,
voluntarily and consciously assumes and
accepts these risks, and releases SHARK
from any liability up to the maximum
limit admissible by law, for any damage
that may result therefrom.

Publicidad

loading