Shark RS-JET CARBON Manual página 30

ASSEMBLY OF THE INTERIOR
- Reposition the cheek pads by
passing the chin strap through the
slit in the foam (Fig. A) and attach
the Velcro (Fig. B).
- Start the operation by threading
A
the plastic part of the front of the
liner into its housing (Fig. C), starting
with one of the sides.
- Position the textile correctly.
- Reassemble the neck guard using
the following method: first insert
one of the front ends of the neck
guard (use the black attachment
pin attached to the shell); continue
by inserting the central part of the
B
neck guard and locking it in the shell;
finish by inserting the second front
end of the neck guard and locking
everything in the shell. Check that
the liner is in the right direction.
WARNING! Interior positio-
ning is critical for keeping
the helmet on your head. If you are
unsure about disassembling or reas-
C
sembling the interior, do not use
your helmet. Contact your retailer
for assistance and advice. Never
use a helmet missing any part ma-
king up its interior, it will not pro-
tect you in the event of an accident.
WARNING! The shell and in-
ner liner are made to fit per-
fectly on your head. In the event
of an accident, a helmet that does
D
not fit you may come off, leaving
your head unprotected and cau-
sing serious or even fatal injuries.
If you are not sure that the interior
has been reassembled correctly, do
not use your helmet. Contact your
retailer for assistance and advice.
E
11