Harman AKG WP-300 Guia Del Usuario página 21

Idiomas disponibles

Inserting batteries in the transmitter

1) Pull the battery compartment cover off the transmitter to access the battery compartment;

2) Insert two batteries into the battery compartment conforming to the polarity marks. The transmitter will not function

if you insert the battery the wrong way round.

4) To turn the transmitter on, press the POWER button. If the batteries are in good condition, the DIGITAL DISPLAY

will be lit.

SETTING UP THE RECEIVER & TRANSMITTER

For the receiver and transmitter to establish an audio communication, both equipment should be set up in the same

working frequency. Only this way the audio signal sent to the transmitter will be read by the receiver for it to send the

audio signal in its outputs towards a mixer or amplifier.

How to select frequencies & channels in the RECEIVER

1. AUTOMATIC CHANNEL AND FREQUENCY SELECTION

frequency. At the end of such process, the frequency will be shown in the receiver display.

2. MANUAL CHANNEL AND FREQUENCY SELECTION

2.1. Press and hold

nnel. Then, press "SET" to

confirm it.

WP-300