Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Note
If you'd prefer, you can use the jig and a center punch (not included) to mark for drilling
separately. It is recommended to use a backer board (not included) to protect the back of your
drawer or door from damage when you drill.
1
Install a Knob on a Drawer
a.
Place the knob (2) to find a position you want.
b.
Mark the center on top of the drawer.
c.
Measure the height of the drawer. For this example, the drawer height equals 6 in. (15.2 cm).
d.
If centering, set the bottom of the Alignment Stop (C) at half of the height of the drawer
(e.g., 3 in. (7.6 cm)) and tighten the Thumb Screw (G).
e.
Line up the notch on the center of the Alignment Stop (C) with the center mark on the top of
the drawer.
1a
2
1c
1b
1d
C
G
1e
C
5
Publicidad
