Descargar Imprimir esta página

IKEA RENGORA Manual Del Usuario página 7

Ocultar thumbs Ver también para RENGORA:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
ENGLISH
Filling the rinse aid dispenser
Rinse aid makes dish DRYING easier. The rinse aid dispenser A
should be filled when the RINSE AID REFILL indicator light
the control panel is lit.
B
B
1. Open the dispenser
by pressing and pulling up the tab on
B
the lid.
2. Carefully introduce the rinse aid as far as the maximum (110
ml) reference notch of the filling space ­ avoid spilling it. If this
happens, clean the spill immediately with a dry cloth.
3. Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the tub.
Adjusting the dosage of rinse aid
If you are not completely satisfied with the drying results, you
can adjust the quantity of rinse aid used.
• Switch the dishwasher on using the ON/OFF button.
• Switch it off using the ON/OFF button.
f the appliance by pressing the ON
• Press button
three times ­ a beep will be heard.
• Switch it on using the ON/OFF button.
• The current selection level number and rinse aid indicator
light flash.
f the appliance by pressing the ON
• Press button
to select the level of rinse aid quantity to be
supplied.
• Switch it off using the ON/OFF button.
Setting is complete!
If the rinse aid level is set to ZERO (ECO), no rinse aid will be
supplied. The LOW RINSE AID indicator light will not be lit if you
run out of rinse aid. A maximum of 5 levels can be set according
to the dishwasher model. The factory setting is specific to the
model, please follow instruction above to check this for your
machine.
• If you see bluish streaks on the dishes, set a low number (1­2).
• If there are drops of water or limescale marks on the dishes,
set a high number (3­4).
Control panel
1
2
3 4
5
1
On­Off/Reset button with indicator light
2
Program selection button
3
Salt refill indicator light
4
Rinse Aid refill indicator light
5
Program number and delay time indicator
6
Tablet indicator light
A
A
h
6
8
9
10
7
To download the full version visit www.ikea.com
Filling the detergent dispenser
Usage of detergent not designed for dishwashers may cause
malfunction or damage to the appliance.
in
To open the detergent dispenser press button C.
Introduce the detergent into the dry dispenser D only.
Place the amount of detergent for
pre-washing directly inside the tub.
B
D
A
C
1. When measuring out the detergent refer to the mentioned
earlier information to add the proper quantity. Inside the
dispenser
there are indications to help the detergent
D
dosing.
2. Remove detergent residues from the edges of the dispenser
and close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until
the closing device is secured in place.
The detergent dispenser automatically opens up at the right
time according to the program. If all­in­one detergents are used,
we recommend using the TABLET button, because it adjusts the
program so that the best washing and drying results are always
achieved.
3sec
11
7
Display
8
Half Load indicator light
9
Half Load button
10
Delay button
11
START/Pause button with indicator light / Tab
1
2
3
4
5
6
7
50°
55°
65°
50°
65°
65°
7
7 PROGRAMS

Publicidad

loading