Publicidad
Idiomas disponibles
Idiomas disponibles
Installation with cabinets and wall
Minimum clearance to
side wall on either side of
range is 5"
Fig. D
Anti-tip installation
IMPORTANT SAFETY WARNING!
To reduce the risk of tipping of the range, the range must
be secured to the floor by properly installed anti-tip bracket
and screws packed with the range. Failure to install the
anti-tio bracket will allow the range to tip over if excessive
weight is placed on an open door or if a child climbs upon
it. Serious injury might result from spilled hot liquids or
from the range itself.
If range is ever moved to a different location, the anti-tip
brackets must also be moved and installed with the range.
Instructions are provided for installation in wood or cement
fastened to either the floor or wall.
When installed to the
wall, make sure that screws completely penetrate dry wall
and are secured in wood or metal.
When fastening to the
floor or wall, be sure that screws do not penetrate electrical
wiring or plumbing.
Anti-tip bracket installation
Place the Bracket Using the Template - Bracket
may be positioned on either the left or right side of the
range.
Refer to Fig. 19, Fig. 20, and Fig. 22 to position
the bracket if template is not available.
Mark the floor or wall where left or right side of the
range will be located.
If rear of range is against wall or no further than 1-1/4"
from wall when installed, you may use the wall or floor
mount method (Fig 19).
For wall mount (Fig. 19), locate the bracket by placing
the back edge of the template against rear wall
and the side edge of template on the mark made
referencing the side of the range. Place bracket on
top of template and mark location of the screw holes
in wall. lf rear of range is further than 1-1/4" from wall
when installed, attach bracket to the floor.
FASTEN
BRACKET (watt or FLooR MOUNTING)
.
—p|
|e 1-1/4" Max.
Leveling Leg
~
-Wall Mount
|
|
———
_
as
OT
f p , -Wall Plate
|
if
Nu,
Floor Mount ——¥ |
Lanti-tip Bracket
Fig 19
.
For floor mount (Fig. 20), locate
the bracket by placing back edge of the template
where the rear of the range will be located.
Mark the
location of the screw holes shown in template.
If molding is installed and does not allow the bracket to
fit flush against wall, remove molding or mount bracket
to floor (Fig. 20).
FASTEN
BRACKET (Floor mountiING ONLY)
;
—p
.q— Viore Than
Leveling Leg
4-1/4"
5
c
=
6
z
-
*— wall
i
4
|
|
Floor Mount
We
Lanti-tip Bracket
ig 20
Publicidad
