Descargar Imprimir esta página

RiteAid deluxe automatic Manual De Instrucciones página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Measurement Procedure
Please note: You should always. be seated before and during measurement.
0 Avoid eating and smoking as well as all forms of exertion directly before measurement.
These factors influence the measurement result. Find time to relax by sitting in an
armchair in a quiet atmosphere for about 5 minutes before taking a measurement.
0 Always compare measurements taken at the same time of day, since blood pressure
Note: Comparable blood pressure measurements always require the .same
0 All efforts by the user to support the arm can increase blood pressure. Make sure
measurement arm during the measurement. Use a cushion for support if necessary.
0 If the arm artery lies considerably lower or higher than the heart, an erroneously
high or low blood pressure will be measured! Each 15cm (6 inch) difference in height
the correct cuff is extremely important. Cuff size is dependent upon the circumfer-
ence of the arm (measured in the center). The permissiblerange is printed on the
-- Aloose cuff or a sideways protruding air pocket causes false measurement values.
0 With repeated measurements, blood accumulates in the arm, which can lead to
false results. Consecutive blood pressure measurements should be repeated after a
1 minute pause or after your arm has been held up in order to allow the accumulat-
ed blood to flow
,
If you decide to take your Averaging Mode measurement again be sure to Wait at
least one minute beforehand.

Publicidad

loading

Este manual también es adecuado para:

Bp3ar1-4drite