Publicidad
Idiomas disponibles
Idiomas disponibles
After the cuff has been appropriately positioned on the arm and connected to the blood
pressure monitor the measurement can begin. Remain still during your measurement
a) Press the 0N/0FF/START button. The pump begins to
inflate the cuff. In the display, the Increasing cuff press-tire
is continually displayed
.
Pressure
b) When the device has detected your pulse the heart sym-
'
'
'L-'L
d) When the measurement has been concluded, the meas-
_
- .
fl
ured systolic and diastolic blood pressure values, as well
Measuring
l 1 ! : .
e) The measurement results are displayed until you switch ,
the device off. If no button is pressed for 1 minute, the. .
arate measurements will take place In succession after
Diastolic
'l
which your result is calculated and displayed as a single. .
, L
' _
'L. '
averaged measurement. There is a 15 second resting time
PUlse
7'5
the remaining time and a beep will sound 5 seconds bet-ere
Measurement
complete
If one of the measurements causes an error message. it will
be repeated one more time. If any additional error occurs, the
measurement will be discontinued and error code displayed.
Expanding the averaged measurement to see the three individual readings:
This function allows you to view the three individual measurements used to
calculate the Averaging Mode measurement. After taking an averaging mode
measurement hold the memory button for 3 seconds until you hear a short
beep. (Do not hold the button longer than 1 seconds or you will delete all the
readings in the memory.) Let go of the button and watch the screen. It will
automatically scroll through the three measurements used in the measurement.
A I5
Publicidad
