Specifications - Hitachi WH 8DH Manual De Instrucciones

2. Battery Charger (UC 14YF2)

SPECIFICATIONS

1. Cordless Impact Driver (WH 8DH)
Motor
No-load speed
Capacity
Tightening torque
Bit shank size
Battery (EB9B)
Weight
2. Battery Charger (UC 14YF2)
Input power source
Charging time
Charger
Weight
Pilot Lamp
Cord
DC motor
0–2200/min
5/32" (4mm) – 5/16" (8mm) (Small screw)
3/16" (M5) – 15/32" (M12) (Ordinary bolt)
3/16" (M5) – 3/8" (M10) (High tension bolt)
Maximum 64.5 ft-lbs (900 kg-cm)
Tightening is 15/32" (M12) high tension bolt, when fully
charged in 68° F (20°C) temp.
Tighttening time: 3 sec. (Use hexagonal socket.)
1/4" (6.35mm) Hex.
Nickel cadmium battery
Voltage .......................................................... DC9.6V
Charging & discharging frequency ............. about 1000
3.5 lbs (1.6 kg)
Single phase: AC120V 60Hz
Approx. 60min. (At a temperature of 68°F (20°C))
Charging voltage .......................... DC 7.2–14.4V
Charging current ........................... DC 1.9A
2.9 lbs (1.3kg)
Battery Installation Hole
Nameplate
Fig. 2
Caution Plate
Body
English
11