Publicidad
Problem
Probable cause(s)
Suggested remedy
While listening to ta
Sound is low, intermittent,
or poor quality, noisy,
scratchy, or unsteady.
Heads are dirty.
Clean the heads.
Dolby noise reduction is set in the wrong position.
Set it to match the Dolby NR recording mode.
The deck does not enter the
recording mode.
The erase-prevention tabs are removed from the
cassette.
While listening to compact discs
The display will not show
the correct indication. Disc
play does not start when
you press the play button.
The disc is not positioned correctly in the disc tray.
Attach tape to cover the space left by removal of
the erase-prevention tabs.
Load the disc on the tray correctly.
The disc is loaded upside down.
Reload the disc.
The disc is dirty.
Wipe the disc with a soft cloth.
The disc is scratched.
The disc is badly warped.
Replace the disc with a new one.
The disc is a nonstandard one.
Replace the disc with a different one.
There is condensation inside the CD player.
Switch the power ON, and then wait for 60 minutes
before using the CD player.
"ERROR" appears on the
display.
You tried playing back in the program mode
without programming any tracks.
During one-touch editing
"NO TAPE" appears on the
display.
"CHANGE TAPE" appears
on the display.
While using the rem
The system cannot be
Operated with the remote
control,
No tape is loaded into deck 2.
The erase-prevention tabs are removed from the
cassette.
ote control
The batteries are installed in the reverse polarity.
The batteries are worn.
Program tracks and then press the play button.
Load a tape.
Attach tape to cover the space left by removal of
the erase-prevention tabs.
Reinsert the batteries in the correct polarity.
Replace the batteries with new batteries.
bring the entire system.
Maintenance
Hf Maintenance of external surfaces
To clean this unit, use a soft, dry c!
lf the surfaces are extremely dirty, use a soft cloth dipped in a
soap-and-water solution or a weak detergent solution.
Wring the cloth well before wiping
Wipe once again with a soft, dry cl
foth.
the unit.
loth.
Never use alcohol, paint thinner, benzine, or chemically treated
cloths to clean this unit. Such chemicals may damage the finish of
your system.
@ Tape head care
To assure sound quality for recording and playback, be sure to clean
the heads after approximately every 10 hours of use by the cleaning
tape (sold separately).
103
Publicidad
