Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING THE SADDLE HEIGHT.-
Loosen the saddle post adjustment
knob (B02) slightly by turning it
anticlockwise, move the saddle to a
position comfortable for doing exercise
and then tighten the adjustment knob
(B02) securely by turning it clockwise,
Fig.5.
Stay within the references.
HORIZONTAL
THE SADDLE.-
Loosen the knob (C35) slightly by
turning it anticlockwise, move the
saddle to a position comfortable for
doing exercise and then tighten the
knob (C35) securely by turning it
clockwise, Fig.8.
Stay within the references.
EMERGENCY
SYSTEM.-
This
tensioning
equipped with an emergency braking
system which, when applied with force
produces a sharper braking effect.
MAINS CONNECTION.-
Insert the jack on the transformer
(E07) into the connection hole (E14)
on the main body (bottom, rear of the
machine)
and
transformer (E07) into a 220V mains
supply, Fig.7.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (C26) up or down, as
shown in Fig.8.
ADJUSTMENT
BRAKING
control
(52)
then
plug
MOVEMENT & STORAGE.-
The unit is equipped with wheels,
Fig.9, to make it easier to move. The
wheels located at the front of your unit
make it easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.9.
Store your unit in a dry place,
preferably not subject to changes in
OF
temperature.
MAINTAINING THE MACHINE.-
For health reasons it is necessary to
clean the handlebars and seat after
each class with a disinfectant spray,
as well as removing any sweat from
the bicycle's frame.
Apply anti-rust to the flywheel every
time you clean the machine or at least
once a month.
is
MAINTENANCE EVERY 100
HOURS.-
1. TIGHTENING THE PEDALS.
Even though the pedals are already
fitted, the right-hand pedal (marked R)
screws on in a clockwise direction,
whereas the left-hand pedal (marked
L) does so in the opposite direction.
Maintenance:
the
-The tension of the pedal clip with the
pedal should be checked weekly,
using a 3mm allen key to adjust the
set screw.
-Apply a little oil to the contact point of
the pedal clip with the pedal to ensure
that it locks on.
17
Publicidad
