Publicidad
Idiomas disponibles
Idiomas disponibles
7.2. Connecting the mains adapter
The device is powered by the mains adapter.
Only operate the clock radio using the mains adapter supplied. The mains
adapter has a type plate detailing the technical specifications of the mains
adapter.
Connect the plug of the mains adapter cable to the 9V
device.
Plug the mains adapter into an easily accessible mains socket.
If you do not need to use the device for a relatively long time, take it out of op-
eration by unplugging the mains adapter from the mains power socket!
7.3. Adjusting the aerial
A wire aerial has already been connected to the device for radio reception. Fully unwind
the aerial and arrange it for optimum reception.
7.4. Switching the device on/off
Press the
button to switch on the device. The last station (FM or DAB) set is then
played.
Press the
button to switch the device into standby mode.
When the device is switched on for the first time, it automatically searches for all
DAB stations that can be received and stores them. SYNC... is shown on the
display. The date and time are also set as part of this process. This process may
take a few minutes.
Stored radio stations and the date and time are retained even after the device is
disconnected from the mains.
7.5. Setting the volume
Press the
button to increase the volume.
Press the
button to decrease the volume.
7.6. Sound presets
You can optimise the sound using the sound presets. The following sound presets are
available for this: POP, ROCK, JAZZ, CLASSIC.
Press the EQ button repeatedly to select the required sound preset. The currently select-
ed sound preset is shown on the display.
To switch off the sound presets, press EQ repeatedly until no sound preset is shown on
the display.
18 – English
2.5A connection of the
Publicidad
