Publicidad
Idiomas disponibles
Idiomas disponibles
1.- ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is recommended when assembling
this unit.
Take the unit out of its box and make
sure that all of the pieces are there.
Fig.0
1. Position the machine's rear stand
on the rear stabiliser bar with wheels
(65), insert the bolts (134), fit the
washers (113) (114), insert the bolts
(134) and tighten securely.
Position the front stabiliser bar (120),
paying attention to the red dots, insert
the bolts (134), fit the washers (113)
(114), insert the bolts (134) and
tighten securely.
2. Position the cover (64) on the rear
stand (65), Fig.2. Secure the cover
with the screws (116) and install the
plugs (122).
Position the cover (121) on the front
stand (120), Fig.2. Secure the cover
with the screws (116) and install the
plugs (122).
3.- FITTING THE PEDALS.-
The assembly instructions for the pedals
must be followed to the letter, fitting
these incorrectly could damage the
screw thread on either the pedal or the
crank. Right and left refer to the position
that the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal, marked with the
letter (52R), screws onto the right-hand
crank, also marked with an (R), in a
clockwise direction. Tighten securely.
The left-hand pedal, marked with the
letter (52L), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely, Fig.3.
direction.
Tighten
ATTACHING THE SADDLE.-
Fit the saddle (33), onto the horizontal
saddle tube (32), as shown in Fig.3, fit
the saddle into position and tighten the
nuts on the bracket securely.
ADJUSTING THE SADDLE HEIGHT.-
Loosen the saddle post adjustment
knob
(29)
anticlockwise, move the saddle to a
position comfortable for doing exercise
and then tighten the adjustment knob
(29) securely by turning it clockwise.
HORIZONTAL ADJUSTMENT OF
THE SADDLE.-
Loosen the knob (34) slightly by
turning it anticlockwise, move the
saddle to a position comfortable for
doing exercise and then tighten the
knob (34) securely by turning it
clockwise.
4.- FITTING THE MONITOR.-
Position the handlebar (6) into the
handlebar post (125). Fig. 4. Position
it correctly and then tighten with knob
(126), and washer (127).
Take the monitor (1) and remove the
four screws (2) from the base of the
monitor. Place the monitor (1) on the
holding plate.
Connect the terminal (9) in terminal of
the rear part of the monitor (1) and
terminals
(4R)
monitor using the four screws (2)
removed previously.
ADJUSTING THE HANDLEBAR
HORIZONTALLY.-
Position the handlebar (6) at a
comfortable
exercise but without going beyond the
"MIN INSERT" marks, now tighten
knob (126) securely, Fig.4.
11
slightly
by
turning
and
(4L).
distance
for
it
Attach
doing
Publicidad
