Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING THE HANDLEBAR
VERTICALLY.-
Position the handlebar (6) at a
comfortable
distance
exercise but without going beyond the
"MIN INSERT" marks, now tighten
knob (123) securely, Fig.4.
Important: The tensioning control (16)
is
equipped
braking system which, when applied
with force produces a much sharper
braking effect.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (70) up or down.
MAINS CONNECTION.-
Insert the jack on the transformer (c)
into the connection hole (h) (rear of
the machine) and then plug the
transformer (134) into a 220V mains
supply.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (68)
Fig.6, to make it easier to move. The
wheels located at the front of your unit
make it easier to move it into a chosen
position, by lifting the unit up slightly
and pushing it, as shown in
Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINTAINING THE MACHINE.-
For health reasons it is necessary to
clean the handlebars and seat after
for
with
an
emergency
each class with a disinfectant spray,
as well as removing any sweat from
the bicycle's frame.
doing
MAINTENANCE EVERY 100
HOURS.-
1. TIGHTENING THE PEDALS
Even though the pedals are already
fitted, the right-hand pedal (marked R)
screws on in a clockwise direction,
whereas the left-hand pedal (marked
L) does so in the opposite direction.
Maintenance:
-The tension of the pedal clip with the
pedal should be checked weekly,
using a 3mm Allen key to adjust the
set screw.
-Apply a little oil to the contact point of
the pedal clip with the pedal to ensure
that it locks on. -Oil to the pedal
springs regularly. (Pedal instructions
attached)
2. CHECKING THE TIGHTENING
KNOBS.-
The 3 tightening knobs should be
loosened off and sprayed with a
lubricant to ensure that they remain
operative.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
MANUFACTURER RESERVES THE
RIGHT
SPECIFICATIONS
PRODUCTS
NOTICE.
12
TO
MODIFY
OF
WITHOUT
THE
ITS
PRIOR
Publicidad
