Orbegozo DS 57190 B IN Manual De Instrucciones página 16

DS 57190 B IN
Oil leakage One way valve and the air
ventilation entrance are not tightly
sealed
Leakage from the connection of U-
shaped section and cover
Shake of the body The leaf damaged and causes
shaking
The motor is not tightly hanged
The body is not tightly hanged
Insufficient The distance between the body and
suction the gas top too long
Too much ventilation from open
doors or windows
The machine The fixing screw not tight enough
inclines
The hanging screw not tight enough
(11).ELECTRICAL DIAGRAM.
(12). MAIN PARAMETERS
Rated Input 220V-240V, 50Hz
Rated Power 195W
Lighting Power 2.5W X 2
Motor Power 190W
Drive Mode Single Motor
Speed Speed I Speed II Speed III
Air tube diameter 150MM
Air output
≥642.4m3/h
Air pressure
≥359Pa
Noise 70dB(A)
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose
of the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2014/35/EU and the requirements
of the EMC directive 2014/30/EU.
Take down the one way valve and seal with glue
Take U-shaped section down and seal with soap
or paint
Replace the leaf
Lock the motor tightly
Fixed the body tightly
Readjust the distance
Choose a new place and resemble the machine
Tighten the hanging screw and make it horizontal
Tighten the hanging screw and make it horizontal
16