Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is recommended when assembling
this unit.
Take the unit out of its box and make
sure that all of the pieces are there.
Fig.0
1. Position the machine's rear stand on
the rear stabiliser bar with wheels
(65), insert the bolts (115), fit the
washers
(113)
bolts(115) and tighten securely.
Position the front stabiliser bar (120),
paying attention to the red dots, insert
the bolts (115), fit the washers (113)
(114), insert the bolts (115) and
tighten securely.
2. Position the cover (64) on the rear
stand (65), Fig.2. Secure the cover
with the screws (116) and install the
plugs (122).
Position the cover (121) on the front
stand (120), Fig.2. Secure the cover
with the screws (116) and install the
plugs (122).
3.- FITTING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on either the pedal or
the crank. Right and left refer to the
position that the user adopts when
sitting on the saddle to do the
exercises.
The right-hand pedal, marked with the
letter (52R), screws onto the right-
hand crank, also marked with an (R),
in a clockwise direction. Tighten
securely.
The left-hand pedal, marked with the
letter (52L), screws onto the left-hand
(114),
insert
crank, also marked with an (L), in an
anti-clockwise
securely, Fig.3.
ATTACHING THE SADDLE.-
Fit
the
horizontal
shown in Fig.3, fit the saddle into
position and tighten the nuts on the
bracket securely.
ADJUSTING THE SADDLE HEIGHT.-
the
Loosen the saddle post adjustment
knob
(29)
anticlockwise, move the saddle to a
position comfortable for doing exercise
and then tighten the adjustment knob
(29) securely by turning it clockwise.
HORIZONTAL
THE SADDLE.-
Loosen the knob (34) slightly by
turning it anticlockwise, move the
saddle to a position comfortable for
doing exercise and then tighten the
knob (34) securely by turning it
clockwise.
4.- FITTING THE MONITOR.-
Position the handlebar (138) into the
handlebar post (125). Fig.4.
Position it correctly and then tighten
with knob (126), and washer (127).
Take the monitor (135) and remove
the four screws (139) from the base of
the monitor. Place the monitor (135)
on the holding plate.
Connect the terminal (140) in terminal
of the rear part of the monitor (135)
and terminals (4R) and (4L).
Attach monitor using the four screws
(139) removed previously.
12
direction.
saddle
(143),
saddle
tube
slightly
by
ADJUSTMENT
Tighten
onto
the
(142),
as
turning
it
OF
Publicidad
