Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING
HORIZONTALLY.-
Position the handlebar (138) at a
comfortable
distance
exercise but without going beyond the
"MIN INSERT" marks, now tighten
knob (126) securely, Fig.4.
ADJUSTING
VERTICALLY.-
Position the handlebar (138) at a
comfortable
distance
exercise but without going beyond the
"MIN INSERT" marks, now tighten
knob (123) securely, Fig.4.
Important: The tensioning control (16)
is
equipped
braking system which, when applied
with force produces a much sharper
braking effect.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (70) up or down.
MAINS CONNECTION.-
Insert the jack on the transformer (c)
into the connection hole (h) (rear of
the machine) and then plug the
transformer (164) into a 220V mains
supply.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (68)
Fig.6, to make it easier to move. The
wheels located at the front of your unit
make it easier to move it into a chosen
position, by lifting the unit up slightly
and pushing it.
THE
HANDLEBAR
for
THE
HANDLEBAR
for
with
an
emergency
Store your unit in a dry place,
preferably not subject to changes in
temperature.
doing
MAINTAINING THE MACHINE.-
For health reasons it is necessary to
clean the handlebars and seat after
each class with a disinfectant spray,
as well as removing any sweat from
the bicycle's frame.
MAINTENANCE EVERY 100
doing
HOURS.-
1. TIGHTENING THE PEDALS
Even though the pedals are already
fitted, the right-hand pedal (marked R)
screws on in a clockwise direction,
whereas the left-hand pedal (marked
L) does so in the opposite direction.
Maintenance:
-The tension of the pedal clip with the
pedal should be checked weekly,
using a 3mm Allen key to adjust the
set screw.
-Apply a little oil to the contact point of
the pedal clip with the pedal to ensure
that it locks on.
-Oil to the pedal springs regularly.
2. CHECKING THE TIGHTENING
KNOBS.-
The 4 tightening knobs should be
loosened off and sprayed with a
lubricant to ensure that they remain
operative.
13
Publicidad
