Descargar Imprimir esta página

Costway TQ10193 Manual De Instrucciones página 9

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
PROBLEM:Battery buzzes or gurgles when charging.
This is normal and not a cause for concern.It may also be silent when
charging,which is also normal.
PROBLEM:Charger feels warm when recharging battery.
This is normal and not a cause for concern.
Maintaining Your Plane
▪It is parents' responsibility to check main parts of the toy before using, must
regularly examine for potential hazard, such as the battery, charge, cable or
cord, plug, screws, enclosure of other parts are fastening, and that in the event
of such damage, the toy must not be until that damage had been properly
removed.
Make sure the plastic parts of the plane are not cracked or broken.
Occasionally use a lightweight oil to lubricate moving parts such as wheels.
Park the plane indoors or cover it with a tarp to protect it from wet weather.
Keep the plane away from sources of heat, such as stoves and heaters. Plastic
parts may melt.
Recharge the battery after each use. Only an adult can handle the battery.
Recharge the battery at least once a month when the plane Raider is not being
used.
Do not wash the plane with a hose. Do not wash the plane with soap and water.
Do not drive the plane in rainy or snowy weather. Water will damage the motor,
electric system and battery.
Clean the plane with a soft, dry cloth.To restore shine to plastic parts, use a
non-wax furniture polish. Do not use car wax. Do not use abrasive cleaners.
Do not drive the plane in loose dirt, sand or fine gravel which could damage
moving parts, motors or the electric system.
When not using, all the electrical source should be turn off. Turn off the power
switch and disconnect the battery connection.
16
The following batteries or accumulators
are contained in this electronic device
Battery Type
3FM4.5 6V4.5Ah
Information on the safe removal of the
batteries or accumulators
• Warning: Make sure the battery is completely drained.
• Remove the battery in the power-off state.
• Carefully remove the battery or accumulator.
• The battery or accumulator and the device can now be disposed of
separately.
Our products are suitable for
ASTM F963; GB6675,GB19865; EN71 and EN62115 standard.
Chemical System
Lead(Pb)
17

Publicidad

loading