JBL on tour Manual De Instalación Rápida página 6

on tour Easy Setup Guide
Step 1.
Unpack on tour, wall adaptor and
cable. Read this instruction sheet completely.
on tour specifications
Frequency range: 100Hz–20kHz
Power consumption: 6 W maximum
Transducers: (1) 1-inch full range per channel
Amplifier output power: 3 Wrms per channel
Dimensions:
6.75" (17.1 cm) long
3.5" (8.9 cm) wide
1.5" (3.8 cm) tall
Weight: 1.1 pound = 0.5 kg
Battery
Size - AAA
Type - Alkaline, NiMh
DO NOT MIX BATTERY TYPES
DO NOT MIX CHARGED AND
PARTIALLY CHARGED
BATTERIES
BATTERIES WILL NOT
RECHARGE WHILE IN
ON TOUR
If you have any questions, or need further assistance, please visit www.JBL.com.
*These specifications are subject to change without notice.
6
Step 2.
Open battery compartment
by sliding button as shown. Battery
door will open.
Troubleshooting
Symptom
No sound from on tour
speaker system.
Step 3.
Place (4) fresh AAA batteries
as shown. Replace battery compart-
ment cover. System will function with
AC power only or batteries.
Possible problem
No power to system.
Power adapter plug not
inserted correctly.
Batteries are empty
No volume or low volume.
Input source is low
Step 4.
Open protective cover by
sliding cover as shown. When the
cover is closed, the system will
power off.
Solution
Ensure power supply is connected to live
power source and properly connected to
on tour. Please note: When on tour is pow-
ered, a green power LED should
illuminate.
Replace/ Recharge batteries
Touch the volume "Up" ( + ) pad on the vol-
ume control to un-mute and/or increase
the system volume level.
Note: touching the volume "Down" ( - ) pad
lowers the system volume. Touching both
( + ) and ( - ) volume control pads at the
same time will mute the system.
Increase the volume level on the audio
source device.