JBL on tour Manual De Instalación Rápida página 7

Step 5.
Connect wall adaptor to on
tour. Connect adaptor to wall outlet.
CAUTION - Remove Adaptor from out-
let before installing or replacing batter-
ies.
Symptom
No Power. Green LED is not on.
Green LED is Flashing and there is
No Sound.
This product is intended to be supplied by a Listed Direct Plug-in Power Unit marked 'Class 2 and Output rated 6 Vdc minimum 1.0A.
Step 6. P
lug input cable into
on tour. Plug input cable to audio
device. Start audio device.
Possible problem
Batteries are very low.
Wall Adaptor is not plugged into on
tour correctly.
Wall adaptor is not receiving AC
power.
There is no input signal
Input source is low
Step 7.
Adjust Volume using "+" to
increase and "-" to decrease. Press
both to Mute the on tour Press either
button to Unmute.
Solution
Replace batteries with fresh Akaline AAA or fully charged rechargable bat-
teries.
Check connection of wall adaptor.
Place wall adaptor in a known powered outlet. Test outlet with a lamp or
other device.
Connect on tour to known audio source. Test the audio source with head-
phones.
Increase the volume level on the audio source device.
Step 8.
Green LED indicates that
power is on. Flashing Green LED
indicates no input signal. Amber
LED will flash when batteries need
replacement.
www.JBL.com
7