Asist AE5KR20A Instrucciones De Uso página 59

SAVE THESE SAFETY INSTRUCTIONS !!!
DESCRIPTION
This manual circular saw is designed for cutting
wood, the rear handle is held with the right hand. This
saw is not suitable for stationary use.
1. Dust extraction port
2. Lower cover lever
3. Bottom cover
4. Blade clamping screw
5. Saw blade
6. Guide rail
7. Auxiliary handle
8. Main handle
9. Spindle locking button
10. Guide rail knob
11. Miter angle scale
12. Knob for setting the miter angle
13. Laser switch
14. Lock button
15. Variable speed trigger switch
16. Laser module
17. Motherboard
18. Knob for setting the depth of cut
19. Cut depth scale
25. Accumulator /Li-ion/
26, Battery release button
27. Charging device
28. Battery status indicator
Battery and charger are not part of the delivery
Pictograms
Pictograms listed on the product packaging:
a) Power supply values
b) Power consumption
c) Idle speed
d) Cutting disc diameter
e) Max. cutting capacity (90˚)
f) Max. cutting capacity (45˚)
a b c
USE AND OPERATION
ASIST tools are intended for home or hobby use only.
The manufacturer and importer do not recommend
using this tool in extreme conditions and under high
loads.
Any additional requirements must be the subject of
an agreement between the manufacturer and the
customer.
Inserting and removing the battery
1. Insert the charged battery into the tool handle until
it clicks into place
Check that the battery is securely seated
d e f
locked in place.
To remove the battery, press and hold the button on
the back of the battery and slide the battery out of the
battery slot.
Charging (B)
The battery must be charged before using the device
for the first time.
1. Insert the plug of the AC adapter into a standard
electrical outlet (230V).
2. Connect the charger to the battery charging socket.
3. Normal charging time is about 3-5 hour. The
battery and charger heat up during charging. It does
not indicate a malfunction of the device.
Warning:
Do not charge the battery for more than 6 hours.
Overcharging can shorten battery life.
4. After the battery is fully charged, turn off the
charger by disconnecting the AC adapter from the
mains.
5. If the battery is not in use, store it away from heat
sources.
Recharging the battery:
If the battery is completely discharged, charge it for
3-5 hour. Follow steps 1-5 of the battery charging
procedure. Do not recharge the battery repeatedly
after short use (less than 15 min.). You can extend
the life of the battery if you let it completely discharge
before charging.
CHECKING BATTERY CONDITION
Battery status can be checked using the battery
status indicator (8).
Press and hold the button on the battery status
indicator and the LED indicators will light up.
If 3 LED indicators light up (2 green, 1 red), the
device is fully charged. If 2 LEDs
indicator lights (1 green, 1 red) are lit, the device has
half capacity. If 1 LED indicator (1 red) lights up, the
device needs to be charged soon.
Saw blade replacement (B, C)
! Always unplug the saw before replacing the blade.
! Use only sharp and undamaged discs. Cracked or
bent discs must be replaced immediately.
Hold the spindle lock
Use the wrench to loosen the fixing screw and pull it
out. Remove the flange
Remove the old saw blade and insert the new blade
with the teeth pointing in the direction of rotation ac-
cording to the arrow on the fixed blade guard.
Return the disc cover to its normal position.
59