Publicidad
Idiomas disponibles
Idiomas disponibles
Insert the flange on the disc and use the wrench to
tighten the fixing screw
Release the spindle lock. Insert the Al-
len key back into the holder. Make sure that
the saw blade is properly locked in place.
Cutting depth adjustment (E)
1. Release the depth adjustment lock lever
2. Align the base plate horizontally with the edge
of the workpiece and lift the saw body until the saw
blade is at the correct depth determined by the depth
of the cutting scale and is aligned with the comma on
the scale).
3. Tighten the depth adjustment lock lever.
Bevel angle adjustment (F)
The bevel angle is infinitely adjustable between 0 °
and 45 °.
Loosen the adjusting screws
Set the required bevel angle according to the scale
and tighten the adjusting screws
Installing the parallel guide
The parallel guide allows cuts parallel to the edge at a
maximum distance of 10 cm.
Loosen the adjusting screw
Insert the parallel guide into the saw base
Adjust the parallel guide to the required distance and
tighten the adjusting screw
Operating Instructions
Attach the cut object. Attach it with the side that will
be visible, as this side of the cut is cleaner.
Switch on the saw and let it reach full speed before
you start cutting, i.e. before the disc touches the
material. Do not put too much pressure on the saw,
allow it enough time to cut.
Hold the saw with both hands on both handles. This is
how the saw is best controlled.
For straight cuts along the drawn line, use the straight
cut mark
For bevel cuts along a drawn line, use the bevel cut
mark
Using a laser beam
! Never look directly into the laser beam and never
aim the beam at anyone.
The laser generator is used for precise, precise cut-
ting. Before starting precision cutting, make sure that
the batteries are mounted in the laser generator.
When attaching the batteries, remove the battery
compartment cover, insert the batteries, then replace
the cover. ! Check the correct polarity of the batteries
before attaching them.
When using a laser generator, simply press the laser
switch. The laser generator then projects visible red
light onto the workpiece surface. Make the cut at an
angle along the red bar.
! Dust from the saw can clog the laser beam, so clean
the laser generator regularly.
Switch off the laser when switching off the machine.
The laser does not turn off automatically. If you will
not be using the laser for a long time, remove the
batteries.
Notice!
This product uses a Class 2 laser. Repairs may only
be performed by qualified service personnel.
Switching on and off (I)
The saw is equipped with a safety button to prevent
accidental switching on.
To switch on the saw, hold down the safety button and
press the on / off switch
60
Publicidad
