Descargar Imprimir esta página

Parkside PALP 20-Li C3 Traduccion Del Manual De Instrucciones Originale página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 103
Safety instructions for battery
chargers & blowers
This appliance may be used by
children aged 8 and above and
by persons with limited physical,
sensory, or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the appliance safely and are aware
of the potential risks . Do not allow
children to play with the appliance .
Cleaning and user maintenance
tasks may not be carried out by chil-
dren unless they are supervised .
The charger is suitable for in-
door use only .
WARNING!
If the mains cable needs to be replaced,
this must be carried out by the manufacturer
or an authorised representative in order to
prevent safety hazards .
6 
GB │ IE
Before use:
Charging the battery pack (see fig . A)
CAUTION!
Always unplug the charger before you
remove the battery pack
to the charger .
NOTE
The battery is partially charged . Ideally,
charge the battery completely before use .
This guarantees full battery performance .
Li-ion batteries can be charged at any time
without adversely affecting their service life .
Interruption of the charging process will not
damage the battery .
Never charge the battery pack
the ambient temperature is below 10°C or
above 40°C . If a lithium-ion battery is to be
stored for an extended period, the charge lev-
el should be checked regularly . The optimum
charge level is between 50% and 80% . The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C .
Insert the battery pack
charger
.
Insert the mains plug into the mains socket .
The control LED
that the appliance is charging .
The green LED
indicates that the charging
process is complete and the battery pack
is ready .
Push the battery pack
Switch off the charger for at least 15 minutes
between successive charging sessions . Also
disconnect the power plug from the mains
power socket .
from or connect it
when
into the high-speed
lights up red to indicate
into the appliance .
PALP 20-Li C3

Publicidad

loading