Publicidad
Idiomas disponibles
Idiomas disponibles
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦
Push the battery pack
clicks into place .
Removing the battery pack:
♦
Press the release button
battery pack
.
Checking the battery charge level:
♦
Press the battery charge level button
check the charge level of the battery .
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Operation
This appliance is not designed for continuous oper-
ation . The appliance may be used for a maximum
of 20 minutes of continuous operation . If the appli-
ance overheats, remove the battery pack
the appliance to cool down completely and then
try using it again .
Inflation
♦
Remove the valve cap of the item you want to
inflate .
♦
Fit the appropriate adapter
the air outlet
of the pump .
♦
Push the adapter
of the item you want to inflate .
♦
Switch the appliance on by pressing the
ON/OFF switch
♦
Once the desired level of inflation has been
reached, switch off the appliance by pressing
the ON/OFF switch
♦
Now remove the adapter
♦
Replace the valve cap on the item that you
have inflated .
PALP 20-Li C3
into the handle until it
and remove the
to
as follows:
. Allow
or
onto
,
or
into the valve
,
to the "I" position .
to the "0" position .
or
.
,
Deflation
♦
Fit the appropriate adapter
the air inlet
of the pump .
♦
Remove the valve cap of the item you want to
deflate and push the adapter
the valve of the inflatable item .
♦
Switch the appliance on by pressing the ON/
OFF switch
to the "I" position .
♦
Once the item is fully deflated, switch off the
appliance by pressing the ON/OFF switch
to the "0" position .
♦
Now remove the adapter
Adapters
Adapter
:
For standard valves with an internal diameter of 8
mm .
Adapter
:
For inflatable items with a screw valve . Deflation
is only possible with an unscrewed valve and with
this adapter .
Adapter
:
For inflatable items with a deflation valve .
NOTE
►
The LED work light
you press the ON/OFF switch
illumination of the working area while inflat-
ing in low light conditions .
or
onto
,
,
or
into
or
.
,
lights up as soon as
. This allows
GB │ IE
│
7
■
Publicidad
