Publicidad
Idiomas disponibles
Idiomas disponibles
OUTPUT:
Rated voltage:
Charging current:
Charging time:
Fuse (internal):
Protection class:
* BATTERY AND CHARGER ARE NOT SUPPLIED
Noise emission value:
The measured values have been determined in
accordance with EN 62841 . The A-rated noise
level of the power tool is typically:
Sound pressure level: L
Uncertainty:
Sound power level:
Uncertainty:
Total vibration value:
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841:
Vibration emission value: ah < 2 .5 m/s²
Uncertainty: K = 1 .5 m/s²
NOTE
►
The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with another
tool .
►
The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate .
WARNING!
►
Depending on the manner in which the
power tool is being used, and in particular
the kind of workpiece being worked, the
vibration and noise emission values can devi-
ate from the values given in these instructions
during actual use of the power tool .
►
It is necessary to establish safety measures to
protect the operator based on an estima-
tion of the vibration load during actual use
(wherein all states of operation must be
included, e .g . times when the power tool is
switched off and times where the power tool
is switched on but running without load) .
PALP 20-Li C3
(DC)
21 .5 V
2 .4 A
approx . 60 minutes
3 .15 A
T3.15A
II /
(double insulation)
= 75 .3 dB
PA
K
=
3 dB
PA
L
= 83 .3 dB
WA
K
=
3 dB
WA
General safety
instructions
WARNING!
►
Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury .
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool .
1 . Work area safety
a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents .
b) Do not operate power tools in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control .
2 . Electrical safety
a) Power tool plugs must match the outlet.
Never modify the plug in any way.
Do not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of electric
shock .
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded .
c) Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock .
d) Do not abuse the cord. Never use the cord
for carrying, pulling or unplugging the power
tool. Keep cord away from heat, oil, sharp
edges or moving parts. Damaged or entangled
cords increase the risk of electric shock .
GB │ IE
│
3
■
Publicidad
