Descargar Imprimir esta página

Hitachi Koki UC 18SD Instrucciones De Seguridad Y Manual De Instrucciones página 9

Ocultar thumbs Ver también para UC 18SD:

Publicidad

Idiomas disponibles

Idiomas disponibles

The UC14SD is a charger to be used exclusively for the EB1414 battery.
Avoid charging batteries with the charger other than the EB1414 battery.
While it is possible to insert the 7.2V, 9.6V, 12V and 24V batteries into the
charger lighting up the pilot lamp, please note that no charging can be
made.
The UC18SD is a charger to be used exclusively for the EB1812S battery.
Avoid charging batteries with the charger other than the EB1812S battery.
While it is possible to insert the 7.2V, 9.6V, 12V and 24V batteries into the
charger lighting up the pilot lamp, please note that no charging can be
made.
Inserting a 14.4V battery into this charger will commence charging.
However, do not do so since this may damage the battery and charger.
4. Disconnect battery charger from the receptacle.
CAUTION:
Do not pull the plug out of the receptacle by pulling on the cord.
Make sure to grasp the plug when removing from receptacle to avoid damaging cord.
5. Remove the battery from the battery charger.
Supporting the battery charger with hand, pull out the battery from the battery charger.
Regarding electric discharge in case of new batteries, etc.
As the internal chemical substance of new batteries and batteries that have not been
used for an extended period is not activated, the electric discharge might be low when
using them the first and second time. This is a temporary phenomenon, and normal
time required for recharging will be restored by recharging the batteries 2 – 3 times.
How to make the batteries perform longer.
Recharge the batteries before they become completely exhausted.
When you feel that the power of the tool becomes weaker, stop using the tool and
recharge its battery. If you continue to use the tool and exhaust the electric current, the
battery may be damaged and its life will become shorter.
Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after use. If such a battery is recharged
immediately after use, its internal chemical substance will deteriorate, and the battery
life will be shortened. Leave the battery and recharge it after it has cooled for a while.
CAUTION:
G
When the battery charger has been continuosly used, the battery charger will be heated,
thus constituting the cause of the failures. Once the charging has been completed,
give 15 minutes rest until the next charging.
G
If the battery is recharged when it is warm due to battery use or exposure to sunlight,
the pilot lamp may not light.
The battery will not be recharged. In such a case, let the battery cool before charging.
G
If the battery charger does not work while the battery is mounted correctly, it is probable
that the battery or charger is malfunctioning. Take it to your authorized Service Center.
English
9

Publicidad

loading

Este manual también es adecuado para:

Uc 14sd