Swann SWIFI-4KFLOCAM-EU Guia De Inicio Rapido página 9

The floodlight camera unit is designed to be mounted on a standard wiring junction box and requires
connection to a 100-240VAC power supply. For optimum results, install the unit at least 8 feet (2.4m)
above the ground.
NOTE: BEFORE MOUNTING, ENSURE THE INSTALLATION LOCATION IS WITHIN RANGE OF YOUR WI-FI ROUTER.
SEE "GET STARTED" FOR INFORMATION ON HOW TO CHECK WI-FI COVERAGE.
IMPORTANT! TURN POWER OFF AT CIRCUIT BREAKER.
CAUTION: BEFORE HANDLING ANY WIRING, USE A CIRCUIT TESTER TO CONFIRM THAT POWER IS OFF.
1
If you are replacing an old floodlight unit, disassemble it, along with any existing mounting
bracket from the junction box, and disconnect the wire connections.
2
Press the release tab on the mounting bracket and slide it out of the base of the floodlight
camera.
3
Place the mounting bracket against the surface where you want to install it and mark the location
of the four screw holes. Ensure that there is at least 9cm of clearance around the bracket for the
floodlight camera to slide in and out. If installing on the ceiling, ensure that the release tab is
facing outward.
4
If mounting on a masonry surface or drywall, drill holes and insert the wall plugs provided.
5 Attach the mounting bracket to the surface using the screws provided.
6
Slide the base of the floodlight camera back into the mounting bracket until it snaps into place.
7
Connect the live, neutral, and earth wires of the power cable to the terminal block in your junction
INSTALLATION INSTRUCTIONS
(continued next page)
EN
9