Bosch SDS-clic Manual Del Usuario página 10

10 | English
Use the quick-clamping nut 1 603 340 031 only for bonded
u
grinding and cutting discs and for diamond cutting discs on
an angle grinder with an M14 grinding spindle thread – see
figure A2.
Use the quick-clamping nut 2 608 000 638 for bonded
u
grinding and cutting discs and for diamond cutting discs,
as well as for carbide grinding heads only on a(n) Bosch
angle grinder with magnetic braking function and an
M14 x 1.5 grinding spindle thread – see figure A2.
Only use quick-clamping nuts (3) that are in good working
u
order and not damaged.
Clean the grinding spindle (5), the mounting flange (4) and the
quick-clamping nut (3).
When screwing on, make sure that the printed side of the quick-
clamping nut (3) is not facing the grinding wheel; the arrow (1)
must be pointing towards the index mark (2) – see figure A1.
If the quick-clamping nut (3) is tightened without the arrow (1)
being within the index mark (2), the quick-clamping nut (3) can
1 609 92A 94P | (22.02.2024) Bosch Power Tools