cecotec HYDROSTEAM 3030 ACTIVE Manual De Instrucciones página 42

ENGLISH
Water leakage
Difficult use on
carpets
Oxide in the water tank
You cannot control the
steam level
The mop gets very wet
It stops working
FAQs
Question
Are the cleaning cloths washable and
reusable?
On which floors can I use the steam
cleaner?
Do I need to activate the handle for it to
release steam or is it automatic?
42
HYDROSTEAM 3030 ACTIVE
Loose rubber plug.
Sliding carpet not installed.
The tank has not been
emptied.
The steam cleaner is off.
Inadequate steam level.
Misuse or problem with the
product.
Answer
Yes, the micro-fibre cleaning cloths are
machine washable. Use only liquid detergents.
For better results, do not use softeners nor
bleach. Allow the mop to dry.
The steam cleaner is designed to clean
hard floors, like ceramic tile, vinyl, laminate,
marble, stone, and sealed hardwood floors.
The use of the steam cleaner on waxed or
unwaxed floors may result in a decrease in
gloss.
The steam cleaner releases steam
automatically when you select the steam
level. You can select the steam level by
pressing the steam level button to clean the
floor: Low (delicate floors),
Medium (regular cleaning) and High (resistant
or sticky floors).
Turn the steam cleaner and
remove the water tank.
Tighten the rubber.
Make sure the sliding carpet
is properly assembled in the
mop head.
The remaining water in the
water tank must be emptied
before storing the device.
Press the power switch
and then the steam control
button.
Set a lower steam level.
Contact Cecotec Technical
Support Service.