ENGLISH
Attention
Do not spray water continuously over the same spot.
-
Take special care when using the device to clean stairs.
-
After using the device, hang and wind the power cord in the power cord holder.
-
To know the detergent quantity and use, carefully read the manufacturer instructions.
-
Stop using the device when the water or foam in the waste-water tank reaches the
-
maximum water level and clean the waste-water tank. Otherwise, water may enter the
machine.
5. CLEANING AND MAINTENANCE
Attention
Stop the device and unplug it from the mains before cleaning it.
-
Do not wet the device to avoid the risk of electric shock.
-
Do not use detergents, thinners, benzene, or other chemical agents to clean the device.
-
After every use, you must remove and clean the waste-water tank, the clean-water tank,
-
and the suction nozzle (A/B) to prevent humidity and dirt remains from emitting bad
odours.
5.1. Cleaning the main body
The most common dirt can be cleaned with a slightly damp cloth.
-
The most stubborn dirt can be cleaned with a cloth slightly soaked in detergent and then
-
a cloth slightly soaked in water.
5.2. Cleaning the waste-water tank
1. When the waste water reaches the maximum level, stop using the device and unplug it
from the mains.
2. Remove the waste-water tank. To do so, slide the waste-water tank release tab and
remove the waste-water tank in the direction of the arrow shown in Figure 16.
3. Remove the upper cover of the waste-water tank. Fig. 17
4. Remove the buoy as shown in figure 18, drain the water and clean the buoy and the inside
of the tank by hand.
5. Make sure all parts and components are dry before reinstalling and replace the cover. Fig.
19
6. Place the waste-water tank in the main body of the device.
Attention
Do not lean or shake the waste-water tank when transporting or assembling it; otherwise,
-
waste water will easily leak.
We recommend you empty the waste water before it exceeds the maximum level on the
-
CARPET&SPOT CLEAN LIBERTY
58