Publicidad
Idiomas disponibles
Idiomas disponibles
IW 1/2" 400 18-EC
Reverse Rotation:
Indicator light on control
panel
ON;
OFF
WARNING!
Do not change the working mode while the
tool is running. Sudden change of torque may
cause the loss of control causing possible
injury or damage to the tool or workpiece.
NOTE
The variety of wood density and metal
material may affect the final outcome. The
user should select appropriate mode based
on the application.
NOTE
The LED indicator will turn off approximately
1min after the trigger switch is released.
NOTE
When the tool is next turned on, the working
mode will revert to the previous setting.
Switching on the power tool (see
figure I)
■ To switch the power tool on:
Press the trigger switch 2.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
Working
Maximum IPM
(Impacts per minute)
Mode
1
2
3
A
1000
2700
3750
/
/
■ To switch the power tool off:
Release the trigger switch.
LED light (see figure J)
Press the "drive-control button
" button simultaneously for 2 seconds
until the five indicator lights start flashing,
indicating that the tool has entered the work
light brightness adjustment mode.
In the work light brightness adjustment
mode, each time you press the trigger switch,
the brightness will change to the next level
and will a cycle among the following six
brightness levels.
1
2
Light off Lowest
Press the drive-control button or "M" Button
to exit the work light brightness adjustment
mode. If there is no operation for 5 seconds,
the tool will automatically exit the brightness
adjustment mode.
The next time the tool is turned on and the
memory function will remember and revert to
the last work light brightness level.
The light will turn off automatically
approximately 10 seconds after the trigger
switch is released.
Application
Fine-tuned loosening of
small bolts and nuts.
Moderate loosening
torque.
Maximum loosening
torque.
Loosening with automatic
stop.
Greatly increase the
screwing speed while
loosening wood screws.
" and "M
3
4
5
Highest
6
17
Publicidad
