Chauvin Arnoux PEL103 Guia De Inicio Rapido página 5

QUICK START GUIDE FOR THE PEL102, PEL103 AND PEL104 (EN)
V1 V2 V3
1000V CAT III
POWER & ENERGY LOGGER
Mains plug.
Selection key.
Press the key and hold it down. The REC, ,
Release the key while the desired function is lit.
If you release it while the REC indicator is lit, recording starts or stops.
„
If you release it while the
„
If you release it while the
„
If you release it while the
„
N I1 I2
600V CAT IV
PEL 104
POWER & ENERGY LOGGER
OL
indicator is lit, the Bluetooth link is activated or de-activated.
indicator is lit (PEL104 only), Wi-Fi is activated or de-activated.
indicator is lit (PEL104 only), 3G-UMTS/GPRS is activated or de-activated.
Measurement terminals
I3
Rigid moulded elastomer housing.
Backlit LCD display unit.
Enter key
Navigation key.
ON/OFF key.
To put the instrument into operation, connect the
„
terminals to mains.
To stop the instrument, disconnect the terminals
„
and press the button for several seconds.
You cannot switch the PEL off while it is connected
to a power source or while recording is in progress
(or pending).
11 indicators providing status information.
USB connector and Ethernet RJ45, slot for the SD
card and the SIM card.
and indicators light one by one, for 3 seconds each.