Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
The lever handle controls the flow of hot and cold water to the faucet. Rotate the handle out and
forward for cold water. Rotate the handle out and backward for hot water. Moving the handle
outward opens the cartridge and causes water to flow from the spout. The degree of handle opening
determines the volume of water flow. Returning the handle to the original position toward the faucet
body stops the flow of water.
CARE AND CLEANING
Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these
will dull the finish and void your warranty.
TROUBLESHOOTING
If a faucet installation doesn't deliver water properly or leaks, finding the cause and fixing it can be easy.
PROBLEM
POSSIBLE CAUSE
Faucet leaks
Cartridge retaining nut has
underneath handle.
come loose or the ceramic
cartridge seal is dirty or out
of place.
Water does not
Ceramic cartridge discs
completely shut off.
are worn or have debris
trapped inside.
Faucet has an
The aerator is dirty.
improper water
pattern.
No water pressure
The connector is blocked.
or low water
pressure after a
longer period of use.
The mounting nut
The quick-install mounting
will not tighten on
nut was not pushed upward
the faucet shank.
over the faucet shank before
rotating.
SOLUTION
1. Move the handle to the OFF position. Unthread the handle screw
and remove the handle.
2. Tighten the cartridge retaining nut by turning it clockwise. Move the cartridge
stem to the ON position. The leak should stop draining out from around the
cartridge.
3. If the leak does not stop, shut off the water supply. Remove the cartridge
retaining nut by turning it counterclockwise. Lift out the ceramic cartridge.
Inspect the seal on the bottom of the ceramic cartridge. Remove any debris
from the seal. If the ceramic cartridge seal is twisted or out of place, re-seat
it. If the ceramic cartridge seal is worn or damaged, replace the cartridge by
calling customer service.
4. Position the cartridge back into the faucet body. Make sure the two guide
posts on the bottom of the ceramic cartridge fit into the guide holes in the
cartridge base inside the faucet body. Tightly screw the cartridge retaining nut
onto the faucet body.
5. Reinstall the handle.
1. Shut off the water supply.
2. Move the handle to the OFF position. Unthread the handle screw
and remove the handle.
3. Remove the cartridge retaining nut. Lift out the ceramic cartridge.
4. Position the new ceramic cartridge into the faucet body. Make sure the two
guide posts on the bottom of the ceramic cartridge fit into the guide holes in
the cartridge base inside the faucet body. Tightly screw the cartridge retaining
nut onto the faucet body.
5. Reinstall the handle.
1. Remove the spray head by unscrewing it from the hose assembly.
2. Soak the aerator portion of the spray head in vinegar or cleaner to break up
mineral deposits.
3. Thread the spray head back onto the hose and tighten.
1. Remove the spray head by unscrewing it from the hose assembly.
2. Hold the end of the hose assembly down into the sink and turn the faucet on to
the warm position where it mixes the hot and cold water. If the water flow is still
slow or completely blocked, please call customer service.
1. Push the quick-install mounting nut upwards over the faucet shank until it is
pressed firmly against the underside of the sink and turn to tighten.
6
Publicidad
