Maytag Performa MD2300 Guia Del Usuario página 5

Step
Cont.
Time Dry/Air Fluff
This cycle can be used to regulate the drying time.
Use with Air Fluff, Low, Medium (Select Models) or
Regular temperature settings. For timed drying,
turn the control dial until the pointer points to the
proper time setting in the Time Dry/Air Fluff cycle.
NOTE: Using the Air Fluff temperature setting will
require a longer drying time.
Step
Press Start
Push this button to start the dryer. The dryer door
must be shut for the dryer to operate. If the door is
opened during the cycle, the Start button must be
pushed again to resume the cycle once the door is
closed.
End of Cycle Signal
Shortly before the cycle is complete, an audible signal
will sound.
Special Options
Damp Dry is located on the Time Dry/Air Fluff sec-
tion of the dial. It is designed to partially dry items
and can be used with any temperature selection.
Damp Dry will provide 20 minutes of tumbling
time, followed by 5 minutes of cool-down tum-
bling.
Wrinkle Release will release wrinkles from items
that are clean and dry but only slightly wrinkled,
such as from a crowded closet or suitcase, or from sit-
ting in the dryer too long after the cycle has ended.
Wrinkle Release provides 10 minutes of tumbling
followed by five minutes of cool-down tumbling
and can be used with any temperature selection.
NOTE: The dial can be turned M either direction to
select a cycle. Once started, the dial will not advance
at a specific rate during the Auto Dry cycles. At first
the dial may not advance at all. Toward the end of the
cycle (when the load begins to dry) the dial will
advance at a more regular rate and much more quick-
ly. This is normal operation.
Start
4