Publicidad
Idiomas disponibles
Idiomas disponibles
When using detergents, the material data safety
sheet issued by the detergent manufacturer must
be adhered to, especially the instructions regarding
personal protective equipment.
6.1. STOPPING USAGE OF THE MACHINE
Do not unscrew the high pressure hose straight after
stopping usage. When not pressing the trigger of the
gun, there will be water from the pump to the gun
which will make unscrewing the connectors practically
impossible straight after use and if you do manage to
unscrew these, there will be danger of injury.
When stopping use:
1. Place the switch in the ¨o¨ position.
2. Close the winter intake tap.
3. Press the trigger of the gun until water stops
coming out from the tip of the lance.
4. Disconnect the water intake hose of the machine.
5. Connect the machine again by placing the switch
in the ¨1¨ position.
6. Press the trigger of the gun again so that all the
water inside the machine empties. This only lasts
a few seconds. Do not maintain the trigger pressed
further as you could work in dry conditions and
damage the pump of the machine.
7. Disconnect the machine again by placing the
switch in the ¨o¨ position.
8. Disconnect the cable from the mains.
9. Tidy up and place the electric cable on its support as
well the high pressure hose and gun to avoid accidents.
7. MAINTENANCE AND SERVICE
The removal of security devices, inappropriate
maintenance or the substitution of parts by non
original parts could cause severe injuries.
Always do maintenance work with the
machine unplugged from the mains.
The following maintenance work should be done once
you have finished working with the machine to ensure
a proper and adequate use the following time the
machine is used:
- Clean all the connectors eliminating any existing
dirt.
- Clean the nozzles with the wire supplied with the
machine.
31/96
English
Publicidad
