Mounting The Tool; Operating The Tool (Rotation Model) - IKRA BAS 3018 Instrucciones De Manejo

Flush-cutting thick branches
• If branch diameter is more than 4" (10 cm), first per-
form undercut (3) and then cross-cut at a distance (A)
of about 8" (20cm) from the final cut.
Then carry out the flush-cut (4), starting with a reliev-
ing cut and finishing with a cross-cut.
Cutting above obstacles
The unit's long reach makes it possible to prune branches
that are overhanging obstacles, such as rivers or lakes.
The tool angle in this case depends on the position of
the branch.

Mounting the Tool

Loosen wing screw (1) on the coulping sleeve (2), and
pull the knob (3) and Insert the driver tube (4) until the
lock button secured in place. Screw down the wing screw
(1).
3
1
2

Operating the Tool (rotation model)

If necessary, you can adjust the pole chain saw stepwise.
Push force on the lever plate (1) until out off the teeth (3),
you can rotate the tools.
After the desired position is set loose the lever (1).
Attention: The lever (2) must engage certainly in the in-
terlock (3).
4
GB-13
1
2
3
1