IKRA BAS 3018 Instrucciones De Manejo página 45

6. Reference
Ratings
Model
Engine output
Engine type
Cubic capacity
Fuel
Tank volume
Oil tank volume
Maximum engine speed
Idling speed
Chain speed
Cutting length
Chain type
Fuel consumption
Weight
Noise level
Vibration
Technical changes reserved.
Notice: The vibration value indicated was determined with a standardized tool and can be used to make comparisons
with other petrol equipment as well as temporary estimates of the load through the vibrations.
WARNING! The vibration value may vary according to the usage of the machine and its fitted equipment, and be
higher than the one indicated. Safety measures must be established to protect the user and must be based on the load
estimate generated by the vibrations in real usage conditions. In this regard, all the operational cycle phases must be
taken into consideration, such as switching off or idle running.
Warning: Prolonged exposure to vibrations can cause injuries and neurovascular disorders (also called "Renaud's
syndrome"or "white hand"), especially to people suffering from circulation disorders. The symptoms can regard the
hands, wrists and fingers and are shown through loss of sensitivity, torpor, itching, pain and discolouring of or structural
changes to the skin. These effects can be worsened by low ambient temperatures and/or by gripping the handgrips
excessively tightly. If the symptoms occur, the length of time the machine is used must be reduced and a doctor
consulted.
When working with the device, a certain level of noise cannot be avoided. Noisy work should be scheduled for hours,
during which it is allowed by statute or other local regulations. Adhere to any applicable rest times and limit your work-
ing time to the necessary minimum time. For your personal protection and the protection of people nearby, suitable
hearing protection must be worn.
We, ikra GmbH, Schlesier Straße 36, D-64839 Münster / Altheim, declare under our sole responsibility that the
product Pole chain saw BAS 3018 to which this declaration relates correspond to the relevant basic safety and
health requirements of Directives 2006/42/EC (Machinery Directive, 2004/108/EC (EMV-Guideline), 97/68/EC as
amended by 2002/88/EC, Anex IV and 2000/14/EC (noise directive). For the relevant implementation of the safety
and health requirements mentioned in the Directives, the following standards and/or technical specification(s) have
been respected:
EN ISO 11680-1:2011; EN ISO 11806-2011; EN ISO 10517/A1:2013
Type examination certificate No. M6A 15 01 32082 104; TÜV SÜD Product GmbH, Identity no. 0123
measured acoustic capacity level
guaranteed acoustic capacity level
Conformity assessment method to annexe V / Directive 2000/14/EC
The year of manufacture is printed on the nameplate and can be additionally retrieved via the consecutive serial number.
Münster, 04.03.2015
Maintenance of technical documentation: Gerhard Knorr, Kärcherstraße 57, DE-64839 Münster
kW
cm³
lubricated petrol
ml
ml
min
-1
min
-1
m/s
mm
kg/h
kg
dB (A)
m/s
2
EC Declaration of Conformity
109 dB(A)
112 dB(A)
Gerhard Knorr, Technical Management Ikra GmbH
GB-20
BAS 3018
1,0
2-stroke
30
40:1
600
150
10.500
3.000
21
200
Oregon 91PJ033X
0.38
7,2
102
[K=3,0 dB(A)]
13,3
[K=1,5 m/s²]