Makita DCL182 Manual De Instrucciones página 5

Ocultar thumbs Ver también para DCL182:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE:
Depending on the conditions of use and the
ambient temperature, the indication may differ
slightly from the actual capacity.
Switch action
1
3
011542
To start the cleaner, simply press the "HIGH/LOW" button.
To switch off, press the "OFF" button. To change the
cleaner speed, press the "HIGH/LOW" button. The first
press on this button is for high speed and the second
press for low speed and then each press on this button
repeats the high/low speed cycle alternatively.
Battery power lamp
1
3
011542
When the remaining battery capacity gets low, the
battery power lamp blinks.
When the remaining battery capacity gets much
lower, the tool stops during operation and the
battery power lamp lights up for about ten seconds.
At this time, remove the battery cartridge from the
tool and charge it .
NOTE:
The time at which the battery power lamp start
blinking or lighting up depends on the temperature
at work place and the battery cartridge conditions.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
1. OFF button
2
2. HIGH/LOW
button
3. Battery power
lamp
1. OFF button
2
2. HIGH/LOW
button
3. Battery power
lamp
Disposing of Dust
CAUTION:
Empty the cleaner before it becomes too full, or the
suction force weakens.
Be sure to empty out the dust inside the cleaner
itself. Failure to do so may cause the sponge filter
to be clogged or the motor to be damaged.
Never throw away the dust stopper because it
should be used whenever either the dust bag or the
dust pack is used.
1
2
011551
1.
Push the button to open the front cover. Opening it
until a click is heard allows a positive stop at that
position.
011553
NOTE:
The cleaner is constructed in such a way that the front
cover comes off when trying to force the front cover
open at the angle of more than 90°. If the front cover
comes off, insert it into the front cover joint in place.
CAUTION:
When closing the front cover, be careful not to
pinch your fingers.
1
011552
2.
Pull out both the orange-colored dust stopper and
dust bag together at the same time.
5
1. Front cover
2. Button
1. Front cover
1
2. Front cover joint
2
1. Dust stopper

Publicidad

Tabla de contenido
loading

Tabla de contenido