Publicidad
Idiomas disponibles
Idiomas disponibles
If you have further questions regarding the
engine, please refer to the engine manual
included with the unit.
STEP 3:
Check oil level. Oil level should always be
between the "FULL" and "MAX" marks on the
dipstick as shown in the picture below.
FULL / MAX
Be sure the machine is level when checking
the oil level. (Refer to the engines operating
manual for seasonal grades).
STEP 4:
Fill gasoline tank with unleaded gasoline.
Do not use leaded gasoline. Cosult engine
manual for appropriate octane rating
Do not add oil to the gasoline.
STEP 5:
Connect the high pressure hose to the high
pressure outlet on the pump .
WARNING
High pressure hoses, fittings and couplings
are important for the safety of the appliance.
Use only hoses, fittings and couplings recom-
mended by the manufacturer.
STEP 6:
Connect garden hose to unit's water inlet
STEP 7:
Connect garden hose to the cold water source
and turn water completely on.
10
OPERATING INSTRUCTIONS
ADD / MIN
Do not use hot water. (Water supply tem-
perature must not exceed 104°F/40°C).
STEP 8:
Unlock the trigger gun safety lock. Pull Trigger
gun to eliminate trapped air, wait for a steady
flow of water to emerge from the spray nozzle.
STEP 9:
Open choke lever (RUN position on a warm
engine), open fuel valve.
STEP 10:
Turn ON/OFF switch to ON position.
STEP 11:
Pull the starter handle. If the engine fails to
start after 3 pulls, squeeze the trigger gun to
release pressure, and repeat step.
After the engine warms up enough to run
smoothly push choke to run position.
WARNING
Starter cord kickback (rapid retraction) can
result in bodily injury. Kickback will pull hand
and arm toward engine faster than you can
let go. ALWAYS relieve spray gun pressure
before pulling starter cord. Pull starter cord
slowly until resistance is felt, then pull rapidly.
For engine details see engine manual.
Publicidad
