General Safety Regulations - Hillyard Trident BU1500 Manual De Uso Y Mantenimiento

The regulations below must be carefully followed in order to avoid harm to the
operator and damage to the appliance.
DANGER:
• To reduce the risk of fire, electric shock or injury, read and follow all safety and
warning instructions before use. This Vacuum Cleaner is designed to be safe
when used for cleaning functions as specified. In the event of damage to electrical
or mechanical components, it is necessary to repair the vacuum cleaner and / or
accessory concerned at a competent service center or the manufacturer prior to use
to avoid further damage to the appliance or injury physical to the user.
• Before connecting the appliance to the power outlet, check that the electrical data
on the nameplate corresponds to those of the power supply. The appliance must
only be powered by alternating current and with a voltage equal to that indicated on
the serial number plate.
• The power cord outlet must be earthed.
• The power supply cable supplied with the appliance must be used for the aforesaid
appliance and not for other appliances.
• Check for damage to the connection line and the power plug before each use. If the
line is damaged contact a technician immediately to restore the correct operation.
• Connect the appliance only to an electrical connection installed by an electrical
installer in accordance with IEC 60364-1.
• Never touch the power plug with wet hands.
• Be careful that the power cord or extension cord will not be damaged by passing,
crushing, pulling or the like. Protect the cable from heat and contact with sharp oils
or edges.
• Regularly make sure that the power cord is not damaged, for example with cracks
or aging. If a damage is detected, the cable must be replaced before reusing the
appliance.
• Water splash protection and mechanical resistance must also be ensured even after
the cable or cable extension joints have been replaced.
• Do not clean the appliance with a hose or high pressure water jet (risk of short
circuits or other electrical faults).
CAUTION:
The insertion transient causes a temporary voltage drop.
Under unfavorable network conditions, other equipment may be damaged.
These damages are expected if the network impedance is less than 0.15Ω.

GENERAL SAFETY REGULATIONS

CONNECTION TO THE ELECTRIC TAKING
7
7 7