Giordani POLARIS Manual De Instrucciones página 24

ISOFIX + adult safety belt. If you
don't have ISOFIX, please ignore this
step. Install the child safety seat with
an adult safety belt only. Pull out the
belt from the belt ALR (Automatic
Locking Retractor). Pass the shoulder
belt through the same side of the
Belt Guide (14) on the headrest,
then pull the shoulder belt and lap
belt together through the other Belt
Guide (16) on the seat base. Insert
the tip of the buckle into the vehicle
seat buckle until it engages with a
clicking sound. Follow the direction
of the arrow to tighten the belt and
put the redundant belt into the ALR.
Wiggle the child safety seat to make
sure it is securely attached.
TIP!
the belt guide position between
the outside of the neck and the
shoulder (in the middle of point a
and point b).
WARNING!
must not be twisted or put in a
different place.
TIP!
the lap belt is worn low so that the
pelvis is firmly engaged.
TIP!
must run diagonally backward.
The alignment of the belt can be
adjusted with your vehicle's ALR on
both sides.
Seat cover
Only use authentic POLARIS Seat2
Covers (4). The Seat Cover (4) is an
integral part of the child safety seat
R398_POLARIS_(C 07)_Libretto_v3.indd 24 R398_POLARIS_(C 07)_Libretto_v3.indd 24
Keep the shoulder belt in
The adult seat belt
It is important to ensure that
The shoulder belt section
8. CARE
AND MAINTENANCE
and is crucial to ensuring trouble-
free operation of the system.
Replacement Seat Covers (4) are
available from your dealer.
The Shoulder Pads (5), Seat Cover
(4) and Seat "Cradleyou" Reducer
(15) can be washed in lukewarm
soapy water. Remove all foam parts
from the top and bottom sections
before washing. These must not be
washed.
TIP! Use the seat cover R-elf to
assemble the cover more easily.
Harness Buckle
1. Open the Harness Buckle (7) as
shown. Remove Groin Pad (8) .
2. Lift the seat cover and pull down
the Harness Buckle (7) across the
Seat Cover (4).
3 . Ro tate th e m etal p l ate o n
the groin straps from (F) by 90°
vertically. Slide the metal plate
through the harness slot so that
(E) is in a horizontal position,
then the Harness Buckle (7) can
be pulled out from the slot (D).
To re-install the Harness Buckle (7),
follow the steps in reverse order
until the metal plate is hooked into
the harness slot. Pass the Harness
Buckle (7) through the Groin Pad (8)
on the cover. Make sure the metal
plate is under slot (F) during use.
WARNING! Tug hard on the groin
strap to make sure that it is secure
in the seat shell.
To ensure your child's safety, it
is absolutely essential that the
H a r n e s s B uck l e ( 7 ) co n t i n ue s
to function correctly. Harness
24
Buck
caus
or by
press
it tak
Tong
Buck
enga
them
The B
witho
Buck
push
The B
if extr
soak
water
for a
buck
plasti
be cl
not u
(such
Pleas
regula
Dispos
of pack
Seat co
Plastic
Metal p
Belt str
Buckle
tongue
22/12/23 09:36 22/12/23 09:36