Winix ZERO S Guía De Configuración Rápida página 4

CONTROL PANEL
08
01. Auto Mode Indicator
The LED "Auto" light will indicate when Auto
Mode is activated.
02. Air Quality Indicator
Color coded LED light indicates one of three
levels of Air Quality: Red (poor), Amber (fair),
and Blue (good).
03. Fan Speed Indicator
Indicates the current fan speed.
Auto Mode Low Medium
High
®
04. PlasmaWave Indicator
Indicates whether the PlasmaWave
Technology is enabled or disabled.
05. Sleep Mode Indicator
When Sleep Mode is activated, the Air Quality
Indicator LED light is disabled.
MAINTENANCE
When to Replace Filters
Filter
Pre-Filter
Active Carbon Filter
True HEPA Filter
• When the Check Filter Indicator LED is on, it is time to replace the True HEPA Filter and Active
Carbon Filter.
• Intervals between filter replacement may vary depending on environment.
To purchase replacement Winix filters:
contact your local dealer.
4
01 02
09
06. Filter Replacement Indicator
LED light indicates when it is time to change
the filter.
07. Filter Reset Button
After replacing the filter, turn on the unit and
then use a thin object, such as a paper clip,
to press the Filter Reset button for
5 seconds.
08. Power Button
Turns the unit on or off.
09. Mode Button
Press to cycle through to set the mode of
Turbo
operation (Auto, Sleep).
10. PlasmaWave
® Press the Plasmawave
is on to enable or disable this feature.
11. Light Sensor
Detects the amount of ambient light in the
environment. When in Auto Mode, the Light
Sensor detects when to put the unit into
Sleep Mode.
Indicator Light When to ser vice
none
none
Can NOT be WASHED
Check Filter
03 04 05
10
®
Button
®
button when the unit
When to replace
Clean once every
14 days
Clean once every
3 months
ITEM: 116130
06 07
11
Permanent
Lasts Approx.
12 months
English