Publicidad
Idiomas disponibles
Idiomas disponibles
7. (UP) VOLTAGE POWER
This mode allows you to adjust the device's power up.
The factory default setting is "Auto Check". To adjust, press the button 9 times in a row
1.
until "7.Up" is shown on the display.
When "Po" is shown on the display, it reads the constant power operation (range of
2.
3-15W)
When "Up" is shown on the display, it will read your constant voltage operation
3.
Once your "Po" level is displayed, depress the button to advance to the next higher
4.
setting.
If your variable power is 10 (watts), the display will show 100. If the variable power is 15W,
5.
the display will show 150.
When you reach 150, the device will rotate back around to 3.0 and back up again.
6.
Once you have reached your desired setting, leave the button idle for 2 seconds to lock
7.
in your selection. the device will then resume normal operation. Note: If you are unhappy
Publicidad
