Vaporfi REBEL Manual Del Usuario página 6

1. (UU) ADJUSTING THE VOLTAGE UP
The Rebel's built-in LED display allows you to dial in your preferred voltage level.
1. Press the button 3 times until "1.Uu" is shown on the display.
2. When "Uu" is shown on the display, leave the button idle for 2 seconds.
3. The display will now show the factory default setting of 3.0 Volts. To adjust, simply
depress the button to advance to the next higher voltage setting (3.0, 3.1, 3.2, 3.3, etc.).
When you reach 6.0, the Rebel will reset back to 3.0 volts.
4. Once you have reached your desired voltage level, leave the button idle for 2 seconds to
lock in your selection, and resume to normal operation.
NOTE:
The heating element gets hotter as the voltage level increases. Always start at
a lower voltage setting and increase the power until you are satisfied with the vapor
production. If you are unhappy with your selection, press button 3 times to make another
change.