THOMSON MIC120BT Manual De Instrucciones página 22

Use
FM radio
Carefully extend the telescopic aerial to its maximum length. You can preset up to 50 radio
stations (FM).
Automatic search
1. Press the SOURCE button to select "RADIO" mode.
2. Long-press the
when it finds one with sufficient signal strength (50 preset stations).
3. After a few seconds, the display updates. The screen shows the station frequency.
4. Press MEM to display the pre-set radio stations
5. Press MEM+ or MEM- to listen to the radio.
6. To find other stations, hold the
7. To search the FM band in reverse (high to low frequencies), press and hold the
for 2 seconds.
Manual search
1. Press the SOURCE button on the main unit to select "RADIO" mode.
2. Press or
frequency by 50 kHz up or down.
3. Once you have found a station you want to save, press the MEM button on the remote
control. "P01" is displayed on the screen; press MEM+/MEM- until the desired memory
position number appears. Press MEM again to confirm and store the current station.
4. Press MEM+ or MEM- to display or listen to the radio station.
(Please note: Once you have reached the end of the frequency band, the radio will start
searching for stations again from the other end of the frequency band. If no stations are found,
make sure the aerial is fully extended and test the reception by carrying out another automatic
search in a different location.)
Bluetooth mode
You need to carry out several steps to connect your mobile phone:
1. Activate Bluetooth on your mobile phone (refer to the instructions for your phone).
2. Push the POWER button to turn on the unit, then press the ≡ button repeatedly until the
LCD screen displays "Bluetooth". It will then be ready to be paired automatically.
3. Using your mobile phone, search for the Bluetooth device called "MIC122BT".
4. Your mobile phone will detect "MIC122BT" and ask if you want to connect.
To connect, enter the password 0000 (if applicable). Once the connection is made, the
"Connected" symbol will appear on the LCD screen.
Automatic connection with your smartphone
Pairing is only necessary when you first use the appliance with the phone. Once the device
has been paired with the phone, it will connect to the appliance automatically when it is turned
on and Bluetooth is activated on the phone. The next time you turn on the appliance, it will
automatically connect to the mobile phone it was last connected to.
Press and hold the button to disconnect the Bluetooth.
button and your radio will search for a station and automatically stop
button down as before.
to search for a station. Each press on the tuning button changes the
- EN 22 -
button